Skip to content
CARBON.TJ
Analysis· 2 min read

How a tonne of CO₂ removal with biochar is calculated

Why “2.5 t CO₂ per tonne of biochar” is the upper bound before deductions, and how net removal is derived from it.

What matters to a removal buyer is not the mass of biochar but how much CO₂ stays out of the atmosphere after all deductions. Let’s go through the calculation step by step, the same way our calculator does it.

Step 1. How much biochar was produced

Dry biochar mass: M_b = M_feed × (1 − w) × Y, where M_feed is the wet feedstock mass, w is moisture content and Y is the biochar yield on a dry mass basis.

Example: 1,000 t of feedstock at 0% moisture and a 30% yield gives 300 t of biochar.

Step 2. How much carbon stays stored for the long term

Not all biochar carbon is equally stable. The permanence factor follows the Woolf et al. (2021) model used by Verra VM0044: PR = min(1, c_T − m_T × H/Corg). The coefficients c_T and m_T depend on the mean annual soil temperature.

  • The lower the H/Corg ratio, the more stable the biochar.
  • At H/Corg ≥ 0.7, biochar is not eligible for soil application, and no calculation is made.
  • If PR is below 0.5, no calculation is made either.

Step 3. Removal before deductions

CR_gross = M_b × Corg × PR × 44/12. The 44/12 multiplier converts carbon to CO₂.

For cotton stalks (Corg = 0.65, H/Corg = 0.4, soil at 12.5–17.5 °C): PR = 1.04 − 0.64 × 0.4 = 0.784. Removal before deductions: 300 × 0.65 × 0.784 × 44/12 ≈ 561 t CO₂, or ≈ 1.87 t CO₂ per tonne of biochar.

For orchard prunings (Corg = 0.77, H/Corg = 0.3): ≈ 2.39 t CO₂ per tonne of biochar.

Step 4. Net removal

CR_net = (CR_gross − PE_prod − PE_trans − PE_appl − PE_emb / 5) × (1 − DF). Emissions from production (energy, methane from simple kilns), transport and application are deducted, along with a share of the emissions from manufacturing the equipment; an uncertainty discount is then applied.

The result: a range, not a single figure

For the pilot feedstock, removal before deductions is 1.8–2.5 t CO₂ per tonne of biochar. The net value is lower; the actual number of units is determined by audit and laboratory analyses. That is why we show a range with the label “pre-verification”.